Fukuda Denshi Co Ltd HLX801 Manual Do Utilizador
iv
CAUTION
5. Cares after Operation
y Return all operating switches or knobs to the position before using the
equipment, and then switch off the power.
y When unplugging the cables, do not apply excessive force by pulling on the
cable. Pull from the connector part of the cable.
y Clean the accessories and cables, and keep them together in one place.
y Keep the equipment clean to ensure proper operation for the next use.
y Make sure to remove the batteries if the equipment is not used for a long time.
y Keep the equipment clean to ensure proper operation for the next use.
y Make sure to remove the batteries if the equipment is not used for a long time.
The leakage from the batteries may damage the equipment, or an explosion
from the batteries may occur.
from the batteries may occur.
6. If the equipment gets out of order, immediately turn off the equipment and
ensure patient safety by disconnecting electrodes and cables from the
patient.
Label the equipment "OUT OF ORDER" and contact your nearest
Fukuda Denshi representative.
patient.
Label the equipment "OUT OF ORDER" and contact your nearest
Fukuda Denshi representative.
7. Do not disassemble or remodel the device.
8. Maintenance check
y Make sure to periodically check the equipment and accessories. (Maintenance
contract is recommended.)
y Before reusing the equipment that has been left unused for a while, make sure
that the equipment works normally and safely.
9. When using an electrosurgical unit or defibrillator in conjunction with this
equipment, take care of the following.
y To prevent patient from burn injury, verify proper attachment of patient
ground plate and ECG electrode type when using the electrosurgical knife, and
verify paste volume and output energy when using the defibrillator.
verify paste volume and output energy when using the defibrillator.
y Devices other than the above may cause accidental hazards to the patient and
operator due to the conditions of the equipment. Read the operation manual
attached to each device and understand the precautionary instructions prior to
use.
attached to each device and understand the precautionary instructions prior to
use.
Non-Explosion Proof
DANGER
z Never use the equipment in the presence of flammable anesthetics or high
concentration of oxygen. It may cause an explosion or fire.
z Never use the equipment inside a hyperbaric chamber.
It may cause an explosion or fire.
z Never use the equipment where flammable gas or fluid such as anesthetic,
oxygen, and hydrogen are used.
It may cause an explosion or fire.
It may cause an explosion or fire.