Keystone Heddolf International G220390 Manual Do Utilizador

INSTRUCTIONS FOR Radio Control Operator 

Single entry transmitter G220   

 
Read the following instructions thoroughly before using the remote. 
This transmitter must be adjusted so that the coding switches match the coding on your present operating 
transmitters or receiver   
FCC Regulations: This device complies with Part 15 of the FCC Rules. 
Operation is subject to the following two conditions: (1) this device may not 
cause harmful interference, and (2) this device must accept any interference 
received, including interference that may cause undesired operation.   
 
Programming Remote Controller to the Opener 

Remove the access cover from the front of the transmitter by sliding the cover 
away from the top of the transmitter (Figure A). This will expose the battery 
and the dip switches. The code can now be changed using a small screwdriver. 

You may set your transmitter to any code you desire, but be sure the code you 
set matches both your transmitter and receiver.   
There  are  twelve  (12)  dip  switches,  each  of  which  can  be  placed  in  two 
different positions (+,-). DO NOT set all switches in the same position, such as 
all  +,  all  -,  (Figure  B).  WARNING:  No  other  adjustments  should  be  made 
inside the transmitter. 

For some receivers which only have 9 dip Switches, it will be necessary for 
you to move the small black code terminal (Open the housing with cross-shaped screwdriver (Figure C) to 
find terminal block (Figure D) ) to PINS in the middle and 9 .Therefore, the code selection of the 9 dip 
switches receiver model and the dip switches on your transmitter 1 thru 9 should be set exactly the same. 
The same as those on your receiver, switches 10, 11,12 on the transmitter should be set in the off position. 

 

Open the housing with cross-shaped screwdriver 

Figure C 

Figure A 

Figure B