Uniden America Corporation UC393 Manual Do Utilizador
GETTING ST
ARTED
G E T T I N G S T A R T E D
[ 17 ]
www.uniden.com
Make sure your battery
pack is fully charged
before choosing the
dialing mode.
pack is fully charged
before choosing the
dialing mode.
Choosing the dialing mode
Most phone systems use tone dialing which sends DTMF tones through the phone
lines. However some phone systems such as in rural areas still use pulse dialing.
The default setting is tone dialing. Depending on your dialing system, set the mode
as follows:
lines. However some phone systems such as in rural areas still use pulse dialing.
The default setting is tone dialing. Depending on your dialing system, set the mode
as follows:
1) When the phone is in the standby mode, press and hold
cid/menu. The following screen appears.
2) Press 4 or the vol/- key three times to select “
Dial
”.
3) Press select to toggle between “
Tone
” and “
Pulse
” for
each setting.
4) Press end or return the handset to the base unit to complete the setting.
The handset returns to the standby mode.
• If you are not sure of your dialing system, set for tone dialing. Make a trial call.
If the call connects, leave the setting as is, otherwise set for pulse dialing.
• If your phone system requires pulse dialing and you need to send the DTMF tones for
certain situations during a call, you may “switch-over” to tone dialing. (Refer to
“Tone Dialing Switch-over” on page 21.)
“Tone Dialing Switch-over” on page 21.)
UC393BH (WXI377) OM 4/30/03 11:39 AM Page 17