Motorola Mobility LLC USA-AL200-001 Manual Do Utilizador
Notice (continued)
Proprietary Material
Information and software in this document are proprietary to Motorola, Inc. (or its Suppliers)
and without the express prior permission of an officer of Motorola, may not be copied,
reproduced, disclosed to others, published, or used, in whole or in part, for any purpose other
than that for which it is being made available. Use of software described in this document is
subject to the terms and conditions of the Motorola Software License Agreement.
and without the express prior permission of an officer of Motorola, may not be copied,
reproduced, disclosed to others, published, or used, in whole or in part, for any purpose other
than that for which it is being made available. Use of software described in this document is
subject to the terms and conditions of the Motorola Software License Agreement.
This document is for information purposes only and is subject to change without notice.
Radio Frequency Interference Regulations
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against interference in a residential installation. This equipment generates, uses,
and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the interference by
one or more of the following measures:
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against interference in a residential installation. This equipment generates, uses,
and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the interference by
one or more of the following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and receiver.
– Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
– Consult the dealer or an experienced radio/TV technician to help.
Changes or modifications not expressly approved by Motorola could void the user's authority
to operate the equipment.
to operate the equipment.
Notification of Canadian Requirements
This digital apparatus does not exceed the Class B limits for radio noise emissions from
digital apparatus as set out in the Radio Interference Regulations of the Canadian Department
of Communications.
digital apparatus as set out in the Radio Interference Regulations of the Canadian Department
of Communications.
Le présent appareil numérique n’émet pas de bruits radioélectriques dépassant les limites
applicable aux appareils numériques de classe B prescrites dans le règlement sur le brouillage
radioélectrique édicté par let Ministère des Communications du Canada.
applicable aux appareils numériques de classe B prescrites dans le règlement sur le brouillage
radioélectrique édicté par let Ministère des Communications du Canada.
Note to CATV System Installers in the USA
This reminder is provided to call the cable TV system installer’s attention to Article 820-40
of the National Electrical Code (NFPA 70) that provides guidelines for proper grounding and,
in particular, specifies that the cable shield shall be connected to the grounding system in the
building, as close to the point of cable entry as practical.
of the National Electrical Code (NFPA 70) that provides guidelines for proper grounding and,
in particular, specifies that the cable shield shall be connected to the grounding system in the
building, as close to the point of cable entry as practical.
Part No. 475866-001-00, Rev A. 6/2000
Publication Code: