Motorola Solutions Inc. 92FT7116 Manual Do Utilizador

attachments could damage the radio and may result in non-compliance with RF
safety standards.

The antenna installation must comply with the following requirements in order to
ensure optimal performance and compliance with applicable RF exposure limits.

•

The antenna should be mounted outside the building on the roof or a tower if at
all possible.

•

It is the responsibility of the licensee to manage the site in accordance with
applicable regulatory requirements. Actions such as site survey measurements,
signage, and site access restrictions may be required in order to ensure
compliance with RF exposure limits.

The following explains the operational warnings:

•

Use of a radio transmitter that is not intrinsically safe in a potentially
explosive atmosphere could result in a serious injury or death. You
should only use a certified Intrinsically Safe radio transmitter in
potentially explosive atmospheres.

•

Explosive atmospheres refer to hazard classified locations that may
contain hazardous gas, vapors, dusts, such as fueling areas below
decks on boats, fuel or chemical transferor storage facilities, and areas
where the air contains chemicals or particles such as grain, dust or
metal powders. Areas with potentially explosive atmospheres are often,
but not always, posted.

•

Make sure your radio transmitter is turned off prior to entering any area
with a potentially explosive atmosphere unless it is a transmitter type
specifically certified for use in hazardous location areas.

•

DO NOT remove, install, or charge batteries in such areas, or remove
or install antennas. Sparks in a potentially explosive atmosphere can
cause an explosion or fire resulting in bodily injury or even death.

If your radio transmitter is equipped with a primary or backup battery you must
follow these instructions:

•

Charge your battery using the approved Motorola Solutions charger.

2