Meet Ltd. BT001 Manual Do Utilizador

Page 5 of 5 

transmitter must have their own shielding. However, due to there is no shielding for this 

Bluetooth Module, this module is granted as a Limited Modular Approval. When this 

Bluetooth Module is installed into the end product, a Class II Permissive Change or a New 

FCC ID submission is required to ensure the full compliance of FCC relevant requirements. 

 

USER MANUAL OF THE END PRODUCT: 

In the user manual of the end product, the end user has to be informed that the equipment 

complies with FCC radio-frequency exposure guidelines set forth for an uncontrolled 

environment.  

The end user has to also be informed that any changes or modifications not expressly 

approved by the manufacturer could void the user's authority to operate this equipment. 

If the size of the end product is smaller than 8x10cm, then additional FCC part 15.19 

statement is required to be available in the user manual: This device complies with Part 15 of 

FCC rules. Operation is subject to the following two conditions: (1) this device may not cause 

harmful interference and (2) this device must accept any interference received, including 

interference that may cause undesired operation. 

 

LABEL OF THE END PRODUCT: 

The final end product must be labeled in a visible area with the following" Contains TX FCC 

ID: AZK-BT001 ". If the size of the end product is larger than 8x10cm, then the following 

FCC part 15.19 statement has to also be available on the label: This device complies with Part 

15 of FCC rules. Operation is subject to the following two conditions: (1) this device may not 

cause harmful interference and (2) this device must accept any interference received, 

including interference that may cause undesired operation.