Futaba Corporation T14SG-24G Manual Do Utilizador

● Select the function name 

and return to the Linkage 

menu  by  touching  the 

R T N   b u t t o n . 　 O r   t h e  

H O M E / E X I T   b u t t o n   i s 

pushed.

Sets the travel and limit point of each servo.

The End Point function adjusts the left and right 

servo throws, generates differential throws, and 

will correct improper linkage settings. 

The travel rate can be varied from 0% to 140% 

in each direction on channels 1 to 12(FASSTest 

12CH mode). Also, the limit point where servo 

throw stops may be varied from 0% to 155%.

1. Move the cursor to the travel icon of the 

channel you want to adjust and touch the 

RTN button to switch to the data input mode.

2. Ajust the rate by scrolling the touch sensor.
  Initial value: 100%
  Adjustment range: 0%~140%

*When the RTN button is touched for one second, the rate is 

reset to the initial value.

  Touch the RTN button to end adjustment and 

return to the cursor mode.

3. Repeat this procedure for each rate.

1. Move the cursor to the limit point icon of the 

channel you want to adjust and touch the 

RTN button to switch to the data input mode.

2. Ajust the limit point by scrolling the touch 

sensor.

  Initial value: 135%
  Adjustment range: 0%~155%

*When the RTN button is touched for one second, the limit 

point is reset to the initial value.

  Touch the RTN button to end adjustment and 

return to the cursor mode.

3. Repeat this procedure for each limit point.

●  Select  [END  POINT]  in  the  Linkage  menu  and 

access the setup screen shown below by touching 

the RTN button.

(The display screen is an example. The 

screen depends on the model type.)

Scrolling

● Moving cursor

● Adjusting value

● To next page

(limit point)

(travel)

(limit point)

(travel)