Futaba Corporation T7PX-24G Manual Do Utilizador

Dual ESC

 (Channel setup)

The channel list screen used for the front ESC channel is displayed. Tap the auxiliary chan-

nel that connected the front ESC channel.

- When all channels are in use, a screen saying "No assignable channel" is displayed, please turn off other mixing 

and make an unused channel. You can check the mixing used on the channel setting screen (page 75).

For S-FHSS (analog) 
system, 1 to 7 chan-
nels are displayed.

If there is no assignable 
channel, tap [Close]. Turn 
off other mixing and make  
assignable  channels.

  (Drive ratio adjustment)

Adjust the front and rear motor controller 

operation amount by   or 

  button. The 

  button increases and the   button de-

creases the rear ratio.

Both the front and rear ratios become 

100%

  (Mix mode setting)

Tap "MIX mode" (ON) or (OFF) to select ON / OFF.

"OFF"  :The EXP function of the 2nd CH and other settings are not mixed.
"ON"  :The EXP function of the 2nd CH and other settings are mixed.

  (Trim mode setup)

Tap "Trim mode" (ON) or (OFF) to select ON / OFF.

"OFF"  :The trim of the 2nd CH is not mixed.
"ON"  :The trim of the 2nd CH is mixed.

  When fi nished, return to the Mixing menu screen by pressing the HOME button twice.

Adjustment buttons
- Adjust with the

and

buttons.

- Return to the initial value by 

tapping the [reset] buttons.

Rear rate (Rear mix rate)
 0~100 
 Initial value:100

Setting
- Tap (ON) / (OFF).

Setting
- Tap (ON) / (OFF).

The dial select function can control the drive ratio with digital dial or digital trim.(page 66) 

As this function drives 2 separate motor controllers simultaneously, a mutual load is ap-
plied. Use this function carefully so that the motor controllers are not damaged.
Futaba will not be responsible for motor controller, motor, and other vehicle trouble due 
to use of this function.