Authinx Inc. DS11A Manual Do Utilizador

Remove the screw from the front of the Door/Window Sensor and
install 2 AAA alkaline batteries inside.
Set switch to MAX (left) for windows, or MIN (right) for doors.
Press and hold  the TEST button on the Sensor for a second and then
release it. This initializes the Sensor and picks a random code that is
used when it is registered with the Console.

ENTER PIN
12:00 am

****
12:00 am

1. INSTALL

Entering the PIN clears the top line and shows * for each number entered. The
default PIN is 0000, you’ll find out later how you can change this, but for now press
0000 on the keyboard under the Console’s flip up lid.

This takes you to the first level of the menu at step 1. This is the INSTALLATION
level. The display looks like this:

Press OK and the display looks like this:

Press either of the Console’s 2 Menu up/down buttons (to the right of the display).
The display then shows ENTER PIN (Personal Identification Number) in the top
line.

1. INSTALL
ZONE

Now simply press the TEST button on the Door/Window Sensor. The Console will
acknowledge that it has been registered by displaying ZONE 1 SET.

Repeat this for any other Door/Window Sensors you want to register. The display
increments to ZONE 2 SET, etc. as you install more Door Window Sensors.

If desired, you can specify what zone you want the Door Window Sensor to be
installed into. Just press the number of the zone you want on the Console’s keypad,
and then press the TEST button on the Door Window Sensor.

Press Clear to back out of the menu. After a short delay the display reverts to
showing HOME CONTROL on the top line and the time of day on the bottom line.

• Attach the Door/Window Sensor to the wall using the mounting screws provided.
• Fit the Door/Window Sensor as high as possible at the top of the door/window.
• Make sure the arrows on the magnetic and the Door/Window Sensor are facing

each other and that they separate cleanly when the door or window is opened.

• To protect two doors or windows close to each other, use the Door/Window

Sensor with an additional set of magnetic switch contacts as show in the diagrams
above.

• Set the DELAY slide switch to MIN (to the right) to always trigger the alarm

instantly (for windows), or to MAX (to the left) to trigger the alarm after a preset
entry delay when the system is armed in DELAY mode (for doors).

The numbers 1 –32 in the display refer to up to 32 “zones.” These represent the
Door/Window Sensors (and/or Motion Detectors) you install.  The numbers show
open zones, problem zones and bypassed zones by being displayed as steady on
(door or window open), slow flash (there’s a problem with that zone) or fast flash
(that zone has been bypassed).  Attempting to arm with an open or problem zone
makes the unit beep continuously and the unit will display in words on the display
what the cause is, but only for one zone at a time.  Bypassing that zone (by pressing
the Clear button) moves on to the next problem zone, if there is one.