Authinx Inc. KR33A Manual Do Utilizador

Press and hold the CALL button on the
Panic Button remote for 3-4 seconds
and then release it. This initializes the
remote and picks a random code that is
used when it is registered with the
Console.

Press either of the Menu up/down buttons (under the Console’s
lid to the bottom right of the display). This takes you to the first
level of the menu at step 1. This is the INSTALLATION level.
When you see INSTALL on the display, press OK.

Now simply press CALL on the Panic Button. The Console
acknowledges that it has been registered by beeping and
displaying RMOT 1 SET.

Repeat this for any other Panic Buttons you want to register.
The display increments to RMOT 2 SET, etc. as you install more
Panic Buttons.

Press Clear to back out of the menu. You are asked to confirm,
1. YES, 2 NO. Pressing 1 takes you back to the HOME
CONTROL screen. Press 2 to stay in the INSTALL menu.

Panic Buttons are designed to operate for approximately one
year when fitted with the appropriate batteries. Since operating
conditions vary from installation to installation however, it is
recommended that all batteries are replaced every 6 months.

Providing the batteries have not already failed, they can be
replaced with fresh batteries without the need to reregister the
Panic Button. After removing the old batteries fresh batteries
must be fitted within 30 seconds to ensure that the security
code is retained.

Gently pry the 2 halves of the Panic Button’s case apart and
install two CR2016 lithium batteries in the compartment (+
facing up). Press the 2 halves of the cabinet back together.

Once the batteries have been replaced, confirm that the Panic
Button is still registered in the Console by pressing STOP. If the
Console does NOT chime, the code has been lost and you will
need to proceed as described below.

If the batteries have failed completely, the Panic Button’s code
will have been lost. It will need to be reinstalled following the
procedure the Console’s owner’s manual.