Authinx Inc. AT14A Manual Do Utilizador

3

2

1. Push open the battery

compartment on the
iParty Wireless Sender.

2. Insert the supplied rechargeable

battery. Observe polarity. Replace
only with NiMH AAA 1.2V,
800 mAh rechargeable battery.

Introduction
Send music from your MP3 player to your stereo – without any wires. The
iParty

®

 Wireless Sender plugs into the headphone socket on your MP3 player.

There’s a rechargeable battery in the iParty Wireless Sender (so it doesn’t drain
your MP3 player’s battery). You can charge the battery by removing it from the
Sender and placing it in the compartment in the Receiver.

6. Set the Channel Switch to

match the setting on your
iParty Wireless Sender.

7. Connect the included plug-in

power supply to the Wireless
Receiver and plug the power
supply into an AC outlet near
your stereo

8. Attach the Wireless Receiver to your

stereo’s Audio or AUX input using
the supplied RCA audio cable.

9. Extend the antenna and point it in

the general direction that you
intend to listen to your music from.

10. When the battery in your iParty Sender

goes flat, you can charge it by inserting it
into the compartment in the Receiver. Keep
a spare battery charging in the Receiver so
you can swap the batteries when the one in
your iParty Sender needs to be charged.
The battery should last about 6 hours.

Connecting up the Receiver
The Wireless Receiver connects to your Stereo Receiver, or any audio
component that has an Audio or AUX input. You can then sit back in your easy
chair, up to 50 ft. away from your stereo, and send your music from your MP3
player to your stereo – without any wires!

Lift the Antenna

Plugs into your MP3
Player's headphone jack

3. Attach your MP3 Player to the iParty Wireless

Sender.

4. Set the iParty Sender’s Channel Switch to match

the setting on your iParty Receiver.

5. Move the Sender’s ON-OFF switch to ON.