Bosch Security Systems Inc. H226 Manual Do Utilizador

  

Page 

3 

Quick set-up: 

 
1.  With the Power Switch on the transmitter OFF, install fresh batteries into   

    the transmitter. 
 

2.  To prevent feedback or unintentional noise, mute the audio  

Place the transmitter Power Switch to the ON position. 

 
3.  The operating screen (display) light will come on momentarily. 

    The display will show the current frequency group and channel. 
    Note: Anytime Power is removed and turned back on, the GP/CH 
    screen will be displayed. The Low Battery light will flash momentarily. 

 
4.  If the Group and Channel match the desired receiver group and channel,     

    proceed to Step 11. If not, proceed to Step 5. 

 
5.  To select a different GP/CH, press SET one time. The Group will start 

    flashing. Use the up and down arrows to change the group number. Press 
    the SET button to save the Group. 
 

6.  After setting the Group, The Channel number will start flashing . Use the   

    up/down arrows to change the Channel number. Press SET and the  
    channel is now saved. 
 

7.  There are 18 Groups and up to 16 Channels (preferred groups/channels)   

    stored in memory. If desired, you can create new groups/ channels but  
    you must change to a new frequency to store in that group/channel. 
 

8.  In order to select a new frequency, you must have a “users” group       

     /channel selected. Press the SET button. The Group should be flashing. 
    Press the Up arrow until group 19u (user programmable) is found. 
    (group 20u can also be used) Press SET. The Channel should now be   
    flashing. Select a channel with the up/down arrow. Press SET. 

 
9.  You are now ready to select a frequency to store in the users group  

    above. Press and hold the set and down arrows at the same time for 3  
     seconds and release to go to the next screen function.