Cobra Electronics Corporation MRHH425 Manual Do Utilizador

Nothing Comes Close to a Cobra

®

1. Display will show DCS icon and OFF icon flashing.

NOTE
If DCS was previously set to a Code number, the

display will show the current GMRS channel and flash
the DCS icon and Code number.

2. Codes begin at 01 and go to 83, followed by OFF

and return back to 01 again. Last used GMRS
channel will be shown in the large digit display.

NOTE
If CTCSS is On, then DCS must be Off. If DCS is On,

then CTCSS must be Off.

3. Press Channel Up/Down button to change code

number, or press and hold Channel Up/Down button
to rapid advance (scroll).

4. Press Call/Enter/Setup button to save entry and

move to the next setup programming mode.

The VOX Mode On or Off and VOX Sensitivity Level setup
procedures are the next two settings in GMRS Mode
Programming. Follow the same procedures on page 44, in
Marine (VHF) Setup Programming, to set these functions.

After these two settings have been made, press
Call/Enter/Setup button to save each entry and move to the
next setup programming mode.

MRHH425VP-Body-Eng.qxp:400_Body  10/26/06  1:37 PM  Page 51