Andrew Wireless Innovations Group RPT-MR703P Manual Do Utilizador

U

SER

´

S MANUAL FOR BAND SELECTIVE REPEATERS 

MR

X

03P 

 

 

User'sManual.doc 

Id.-No.:154999 

Page 35 

22-Jan-01 

 

After successful login, the USERID is required. 
 
----------------------------------------------------------------------------------------------------------------- 
ENTER USER ID: 
----------------------------------------------------------------------------------------------------------------- 
 
Please enter 
 

<

UserID1

>

* and confirm with 

<

CR

>

 (carriage return). 

 

* UserID1 is factory set and can be changed by software 

 
Note case sensitivity and blanks! 
 
Now, the correct password is asked. Following order will be displayed on the 
terminal: 
 
----------------------------------------------------------------------------------------------------------------- 
ENTER PASSWORD: 
----------------------------------------------------------------------------------------------------------------- 
 
Please enter 
 

<

P-word1

>

** and confirm with 

<

CR

>

 (carriage return). 

 

** P-word1 is factory set and can be changed by software 

 
Note case sensitivity and blanks! 
 
If the software-login procedure was successful, the input request shown below 
displays on the terminal: 
 
----------------------------------------------------------------------------------------------------------------- 
MIKOM        

>

 

----------------------------------------------------------------------------------------------------------------- 
 
All parameters of the repeater can now be changed to optimize the repeater to the 
network system. 
 

 
A login e.g. via modem at the OMC enables the operator to set parameters and to 
query the status of each repeater. This can be done either via a wireless modem or a 
PSTN-modem. The access commands to the repeater-software are the same as 
described in chapter  5.4.1  Local  Login.  If the OMC is used for the remote login, the 
input “

<

.

>

 (fullstop) and 

<

CR

>

 (carriage return)” is skipped and UserID and Password 

are requested right away.