Glenayre Electronics Inc. GL-T8600-CN Manual Do Utilizador
DSP Exciter
Glenayre Document Number: 9110.00172
MAINTENANCE
Issue 1, Rev. I: 01/15/97
Page: 7-4
Copyright © 1997 Glenayre
Print Date: 02/19/97
Note
When on-the-fly software is used with a QT-1000 interface board
installed in the exciter, only the deviation and offset programming for
mode D is available. References in the exciter menus pertaining to modes
A, B, and C are blanked out.
installed in the exciter, only the deviation and offset programming for
mode D is available. References in the exciter menus pertaining to modes
A, B, and C are blanked out.
7.5.1.1
Release 2.10 DSP Exciter
The C-2000 transmitter controller detects a FLEX baud rate of 1600. When this condition
is detected, the mode control lines to the DSP exciter change it to mode B. If the FLEX baud
rate is not detected, the mode control lines are set for mode A. This requires that mode A
deviation (and offset) be set for POCSAG (512, 1200 or 2400 baud), Golay, NEC and any
other paging format other than FLEX requirements. Mode B deviation and offset must be
set for FLEX. Mode C and D are not used.
is detected, the mode control lines to the DSP exciter change it to mode B. If the FLEX baud
rate is not detected, the mode control lines are set for mode A. This requires that mode A
deviation (and offset) be set for POCSAG (512, 1200 or 2400 baud), Golay, NEC and any
other paging format other than FLEX requirements. Mode B deviation and offset must be
set for FLEX. Mode C and D are not used.
7.6
16-Channel Operation
With 16-channel capability, the on-the-fly digital mode programming is only program-
mable on 8 channels. When channels 1 through 8 are programmed for different modes,
channels 9 through 16 follow the same mode programming respectively (i.e. channel 9 is
the same as 1, channel 10 is the same as 2, etc.). Selecting additional channels (9 through
16) is achieved by the C-2000 controller pulling mode-1 line low to the C-2000 interface
board.
mable on 8 channels. When channels 1 through 8 are programmed for different modes,
channels 9 through 16 follow the same mode programming respectively (i.e. channel 9 is
the same as 1, channel 10 is the same as 2, etc.). Selecting additional channels (9 through
16) is achieved by the C-2000 controller pulling mode-1 line low to the C-2000 interface
board.