Zhejiang Flashforge 3D Technology CO. Ltd. GUIDERII Manual Do Utilizador
GuiderⅡ User Guide | www.flashforge.com
0086-0579-82273989
29
4.4 Unloading Filament
4-11
(4-11) Tap [Tool]-[Unload] and the extruder starts heating up.
4-12
(4-12) After the extruder reaches 220℃, the printer will sound a beep to prompt you to
unload the filament from the extruder. Press the spring presser, press down the
filament for about three seconds and gently pull the filament out.
unload the filament from the extruder. Press the spring presser, press down the
filament for about three seconds and gently pull the filament out.
Note: Do not pull out the filament with force as it will damage the gears. If the
melted filament has cooled down in the extruder, please repeat the steps above.
melted filament has cooled down in the extruder, please repeat the steps above.