Eccel Technology Ltd BIORADRDR0200 Manual Do Utilizador
73
9 Compliance
A. The end equipment that uses this RFID reader module should be tested in its fully operational form to see
that it does not exceed the Transmitter RF emissions permitted by the FCC regulations.
B. The Host device must be affixed with a permanent label that is clearly visible and states the following:
“Contains FCC ID: 2ALHYBIORADRDR0200. Contains IC: 22592-BIORADRDR02”. Please see FCC KDB 784748
D01 Labelling Part 15 &18 Guidelines v08 section 8 and RSP-100 Issue 11 section 3.2 for further details on
labelling requirements.
D01 Labelling Part 15 &18 Guidelines v08 section 8 and RSP-100 Issue 11 section 3.2 for further details on
labelling requirements.
C. The AC powerline conducted emissions test should be performed with the RFID reader module in operation
in its host product if that host product connects to the AC powerline.
D. Changes or modifications not expressly approved by Eccel Technology Ltd could void the user's authority to
operate the equipment.
E. This device complies with Part 15 of the FCC Rules and Industry Canada licence exempt RSS standard(s).
Operation is subject to the following two conditions:
1. This device may not cause interference, and
2. This device must accept any interference, including interference that may cause undesired operation of
the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de
licence. L'exploitation est autorisée aux deux conditions suivantes :
1. l'appareil ne doit pas produire de brouillage, et
2. l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est
susceptible d'en compromettre le fonctionnement.
1. This device may not cause interference, and
2. This device must accept any interference, including interference that may cause undesired operation of
the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de
licence. L'exploitation est autorisée aux deux conditions suivantes :
1. l'appareil ne doit pas produire de brouillage, et
2. l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est
susceptible d'en compromettre le fonctionnement.