Max-Future Electronics Co. Limited M070XX Manual Do Utilizador

Página de 2
NOTE: This equipment has been tested and found to comply with the limits for a 
Class B digital device, pursuant to part 15 of the FCC Rules. These limits are 
designed to provide reasonable protection against harmful interference in a 
residential installation. This equipment generates uses and can radiate radio 
frequency energy and, if not installed and used in accordance with the instructions, 
may cause harmful interference to radio communications. However, there is no 
guarantee that interference will not occur in a particular installation. If this 
equipment does cause harmful interference to radio or television reception, which 
can be determined by turning the equipment off and on, the user is encouraged to 
try to correct the interference by one or more of the following measures: 
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help
Changes or modifications not expressly approved by the party responsible for compliance  
could void the user's authority to operate the equipment.   This device complies with Part 
15 of the FCC Rules.  Operation is subject to the following two conditions:  
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received,  including interference that may
cause undesired operation.  
Part 18 compliance
This device complies with Part 18 of the FCC Rules.
Advisory statement
This product may cause interference to radio equipment and should not be installed near maritime safety communications 
equipment or other critical navigation or communication equipment operating between 0.45 - 30 MHz.
The interference potential 
of the device or system
The interference potential of the device or system is the operating frequency; 0.45 k - 200 kHz. 
Maintenance of the system
Unplug the unit, wait 30 seconds, and plug the unit back in.
Simple measures that can be taken 
by the user to correct interference Move the unit away from any radio device.