LifeSpeed. LLC AMBER1 Manual Do Utilizador

 

 

This watch meets the government's requirements for exposure to radio waves. The guidelines are based 

on standards that were developed by independent scientific organizations through periodic and thorough 

evaluation of scientific studies. The standards include a substantial safety margin designed to assure the safety of 

all persons regardless of age or health. The SAR limit of USA (FCC) is 1.6 W/kg averaged over one gram of 

tissue for body, and 4 W/kg averaged over ten gram of tissue. Device types: GPS Smart Watch (FCC ID: 

2ALOCAMBER1) has also been tested against this SAR limit. SAR information on this and other pad can be 

viewed on‐line at  http://www.fcc.gov/oet/ea/fccid/. Please use the device FCC ID number for search. This 

device was tested simulation typical 0mm wear on wrist and 10 mm to mouth. To maintain compliance with FCC 

RF exposure requirements, use accessories should maintain a separation distance between the user's bodies 

mentioned above, the use of belt clips, holsters and similar accessories should not contain metallic components in 

its assembly, the use of accessories that do not satisfy these requirements may not comply with FCC RF exposure 

requirements, and should be avoided. 

 

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: 

(1) This device may not cause harmful interference, and (2) this device must accept any interference received, 

including interference that may cause undesired operation. 

NOTE 1: This equipment has been tested and found to comply with the limits for a Class B digital device, 

pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful 

interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy 

and, if not installed and used in accordance with the instructions, may cause harmful interference to radio 

communications. However, there is no guarantee that interference will not occur in a particular installation. If this 

equipment does cause harmful interference to radio or television reception, which can be determined by turning 

the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following 

measures: 

- Reorient or relocate the receiving antenna. 

- Increase the separation between the equipment and receiver. 

-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. 

-Consult the dealer or an experienced radio/TV technician for help. 

 

NOTE 2: Any changes or modifications to this unit not expressly approved by the party responsible for 

compliance could void the user's authority to operate the equipment.