Solaborate LLC REM2 Manual Do Utilizador

Página de 11
FCC Statement
 for  HELLO Remote 
FCC ID: 2ALUI-REM2
1. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions:
(1) This device may not cause harmful interference. 
(2)  This  device  must  accept  any  interference  received,  including  interference  that  may  cause 
undesired operation. 
2. Changes or modifications not expressly approved by the party responsible for compliance could
void the user's authority to operate the equipment. 
NOTE:   
This equipment  has been tested and found to comply with the limits  for a Class B digital device, 
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection 
against harmful interference in a residential installation. 
This equipment generates uses and can radiate radio frequency energy and, if not installed and used 
in  accordance  with  the  instructions,  may  cause  harmful  interference  to  radio  communications. 
However, there is  no  guarantee that interference  will not occur in a particular installation.  If  this 
equipment does cause harmful interference to radio or television reception, which can be determined 
by turning the equipment off and on, the user is encouraged to try to correct the interference by one 
or more of the following measures: 
Reorient or relocate the receiving antenna. 
Increase the separation between the equipment and receiver. 
Connect  the  equipment  into  an  outlet  on  a  circuit  different  from  that  to  which  the  receiver  is 
connected.   
Consult the dealer or an experienced radio/TV technician for help. 
FCC Radiation Exposure Statement
The device has been evaluated to meet general RF exposure requirement. The device can be 
used in portable exposure condition without restriction.
This device must not be co-located for operating in conjunction with any other antenna or 
transmitter.
ISED Statement for  HELLO Remote
IC:24458-REM2
Model: HELLORemote2
This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, 
Science and Economic Development Canada’s licenceexempt RSS(s). Operation is subject to 
the following two conditions:
(1)This device may not cause interference.
(2)This device must accept any interference, including interference that may cause undesired 
operation of the device.
Ce dispositif contient les émetteurs/récepteurs autoriser-exempts qui sont conformes au permis 
RSS exempt du Canada d'innovation, de la Science et de développement économique. 
L'opération est sujette aux deux conditions suivantes: 
(1) Ce dispositif peut ne pas causer l'interférence.
(2) Ce dispositif doit accepter n'importe quelle interférence, y compris l'interférence qui peut 
causer le fonctionnement peu désiré du dispositif.
This equipment complies with IC radiation exposure limits set forth for an uncontrolled
environment. End user must follow the specific operating instructions for satisfying RF
exposure compliance. This transmitter must not be co-located or operating in conjunction with
any other antenna or transmitter.