Hangzhou Great Star Industrial Co. Ltd. IL06 Manual Do Utilizador
WARNING:
• DO NOT MIX OLD AND NEW BATTERIES. DO NOT MIX
ALKALINE, STANDARD (CARBON-ZINC) OR
RECHARGEABLE (NICKEL-CADMIUM) BATTERIES.
• DO NOT DISPOSE OF BATTERIES IN FIRE. BATTERIES
MAY EXPLODE OR LEAK. PLEASE DISPOSE OF
BATTERIES PROPERLY.
• REMOVE BATTERIES BEFORE EXTENDED STORAGE.
• NON-RECHARGEABLE BATTERIES ARE NOT TO BE
• NON-RECHARGEABLE BATTERIES ARE NOT TO BE
RECHARGED. BATTERIES ARE TO BE INSERTED WITH
THE CORRECT POLARITY. EXHAUSTED BATTERIES ARE
TO BE REMOVED FROM THE PRODUCT.
AVERTISSEMENT :
• NE COMBINEZ PAS DES PILES USAGÉES AVEC DES PILES
NEUVES. NE COMBINEZ PAS DES PILES ALCALINES,
ORDINAIRES (CARBONE-ZINC) OU RECHARGEABLES
(NICKEL-CADMIUM).
• NE BRÛLEZ PAS LES PILES; CELA POURRAIT ENTRAÎNER
UNE EXPLOSION OU DES FUITES. VEUILLEZ JETER LES
PILES DE FAÇON APPROPRIÉE.
• RETIREZ LES PILES AVANT D’ENTREPOSER LE PRODUIT
PENDANT UNE LONGUE PÉRIODE.
• N’ESSAYEZ PAS DE RECHARGER DES PILES NON
RECHARGEABLES. INSÉREZ LES PILES EN RESPECTANT
LA POLARITÉ. LES PILES DÉCHARGÉES DOIVENT ÊTRE
RETIRÉES DU PRODUIT.
FCC and IC regulations
FCC Part l5
NOTE: This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to Part 15 of the
Federal Communications Commission (FCC) rules. These limits
are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no
guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for
help.
This device complies with Part 15 of the FCC rules. Operation is
subject to the following two conditions: (1) this device may not
cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause
undesired operation. Privacy of communications may not be
ensured when using this device.
WARNING
Changes or modifications, to this equipment not expressively
approved by the party responsible for compliance could void the
user’s authority to operate the equipment.
Industry Canada
This device complies with Industry Canada licence-exempt RSS
standard(s): Operation is subject to the following Two conditions:
(1) this device may not cause interference, and (2) this device
must accept any interference, including interference that may
cause undesired operation of the device.
Le présentappareilestconforme aux CNR d’Industrie Canada
applicables aux appareils radio exempts de licence.
L’exploitationestautorisée aux deux conditions suivantes : (1)
l’appareil ne doit pas produire de brouillage, et (2) l’utilisateur de
l’appareildoit accepter tout brouillageradioélectriquesubi, mêmesi
le brouillageest susceptible d’encompromettre le fonctionnement.
FCC/IC RF Radiation Exposure Statement
Caution: This Transmitter must be installed to provide separation
distance of at least 20cm from all persons.
FCC / IC RF Radiation Déclarationd'exposition
Attention: Cetémetteurdoitêtreinstallé pour fournirune distance de
séparationd'aumoins 20 cm de toutepersonne.