Respironics Inc. 1127941BT Manual Do Utilizador
2ANZ-1127941BT | Regulatory Compliance
Respironics Inc. (Philips Respironics)
1001 Murry Ridge Lane
Murrysville PA 15668
Regulatory Compliance
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) This device must accept any interference
received, including interference that may cause undesired operation.
(1) This device may not cause harmful interference, and (2) This device must accept any interference
received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications.
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio, TV reception, or other devices which can be
determined by turning the equipment on and off, the user is encouraged to try to correct the
interference by one or more of the following measures:
equipment does cause harmful interference to radio, TV reception, or other devices which can be
determined by turning the equipment on and off, the user is encouraged to try to correct the
interference by one or more of the following measures:
Reorient or relocate the receiving antenna (on the radio, TV, or other device).
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer of the device for help.
Any changes or modifications made to the device that are not expressly approved by Respironics may
void the user’s authority to operate the equipment.
void the user’s authority to operate the equipment.
This device is intended only for OEM integrators under the following conditions:
• The antenna must be installed so that 20 cm is maintained between the antenna and users.
• The transmitter module cannot be co-located with any other transmitter or antenna.
• The radio transmitter can operate only using a chip antenna with a maximum gain of 2.2dBi.