CHENGDU LIREN ELECTRIC LTD 830212 Manual Do Utilizador
Wireless LCD Pager (LPG) Quick Start Instructions 830101 (V4)
LCD Caregiver Pager functions directly with Up to 200 wireless transmitting device with
LCD numerical display room number and device number. Each wireless transmitting
device can be programed to a 4 bit digital number including Room number and Location
number on pager. When a resident gets up, the sensor pads active the wireless
transmitter, transmitter will send a wireless signal to the pager, the corresponding Room
number and Location number will flash to alerts caregivers to know Room number and
Location number where wireless device trigger the alarm.
Optional Transmitting devices
- Wireless fully sealed Pad Alarm
- Wireless fully sealed Floor Alarm
- Wireless Nurse Call Transmitter
- Wireless Call Buttons
- Wireless Door/Window Exit Alarm
- Wireless PIR Alarm
- Wireless Deluxe Pad Alarm
- Wireless Deluxe Pad/Magnet Alarm
- Wireless Voice Pad Alarm
- Wireless Voice Pad/Magnet Alarm
- Wireless Basic Pad Alarm
- Wireless Basic Magnet Alarm
- Wireless Basic Pad/Magnet Alarm
- Wireless Door light Alarm
- Wireless Nurse Call Receiver
1.
Open the battery door and Insert batteries as shown.
LPG
Close the battery door.
2.
Program Components to Work with LPG
Before programming the LPG and components, be sure to read through directions for
all of the components you will be programming to work with LPG. Make sure you are
prepared to program all of the components before you begin.
The LPG automatically exits programming mode after 10 seconds of inactivity. If you
are not prepared with all of your components, you may be forced to start again at the
beginning.