Nanjing Wiiking 3D Technology Co. Ltd. WIIBOOX Manual Do Utilizador
wiiboox sweetin Instructions
Model No.: Pro 60
First, connect the printer
Open the first interface, click [SET]-[FILE] on the screen, select [USB] disk, as shown
in the figure:
Second, refueling
Return to the first interface, click [EXTRUDE] in the lower left corner, enter, select the
corresponding extrusion ratio, extrusion speed, and then click [OUT], when you see the E axis
(extrusion axis) screws move to the maximum position (General retracting stroke is 8cm), as
shown below:
Return to the first interface, click [EXTRUDE] in the lower left corner, enter, select the
corresponding extrusion ratio, extrusion speed, and then click [OUT], when you see the E axis
(extrusion axis) screws move to the maximum position (General retracting stroke is 8cm), as
shown below:
After the silk is finished, return to the top page, click [MOVE], enter, select the corresponding
extrusion ratio, click [Z+], generally see the nozzle rises about 4cm, as shown below:
extrusion ratio, click [Z+], generally see the nozzle rises about 4cm, as shown below: