E Ink Corporation ARC00301 Manual Do Utilizador
39
listed here. In each case, “driver 1” refers to the
output connected to the side of the tile or segment at
which the transition is intended to start, and “driver 2”
refers to the output connected to the opposite side (at
which the transition will end). For more information
regarding wave transitions, please see Section 7 of this
manual.
output connected to the side of the tile or segment at
which the transition is intended to start, and “driver 2”
refers to the output connected to the opposite side (at
which the transition will end). For more information
regarding wave transitions, please see Section 7 of this
manual.
IMPORTANT NOTE: If an animation was previously playing on
the master, it will not resume playing when any of the above
commands are completed. It is up to the sensor to issue a
PLAY command with the animation to be run in order to
restart the animation.
the master, it will not resume playing when any of the above
commands are completed. It is up to the sensor to issue a
PLAY command with the animation to be run in order to
restart the animation.
12
discrete-wire connections only, and will accept conductors
within the range of 20-24 AWG.
within the range of 20-24 AWG.
The HD outputs are organized in blocks of ten active outputs
each; each block also provides 12 return connections. Each
block appears as shown:
each; each block also provides 12 return connections. Each
block appears as shown:
These outputs may be used in several ways. Individual tiles or
segments may be connected using 2-pin headers as shown in
example (A) below. Examples (B) and (C) show how multiple
segments may be connected via a single header. In (B), five
segments plus a common return are connected via a six-pin
header. In (C), a twelve-pin header connects ten segments plus
two common return lines.
segments may be connected using 2-pin headers as shown in
example (A) below. Examples (B) and (C) show how multiple
segments may be connected via a single header. In (B), five
segments plus a common return are connected via a six-pin
header. In (C), a twelve-pin header connects ten segments plus
two common return lines.
Connectors for use with the HD outputs may be from any
family providing standard 0.64 mm square pins on 2.54 mm
family providing standard 0.64 mm square pins on 2.54 mm