Gemalto Inc. PR01523 Manual Do Utilizador
Intelligent Document Reader AT10Ki User Guide
Installing the Reader (Legacy USB)
Page 20 of 41
3. Installing the Reader (Legacy USB)
This chapter explains how to install the Gemalto Intelligent Document Reader AT10Ki software and
connect the reader to the PC using the legacy USB interface.
connect the reader to the PC using the legacy USB interface.
Before you begin
Before you install the reader, you need to meet the following requirements:
A PC with an USB 3.1 or 2.0 port (the reader will not work if connected to a USB 1.1 port)
A PC running 32 or 64 bit versions of Microsoft® Windows® XP SP3, Windows Vista®,
A PC running 32 or 64 bit versions of Microsoft® Windows® XP SP3, Windows Vista®,
Windows® 7, Windows® 8.1 or Windows® 10, Linux® builds for Ubuntu and CentOS, 32 bit only.
Additionally macOS is supported (contact Gemalto for more details).
Additionally macOS is supported (contact Gemalto for more details).
Administrative rights to install the software.
If you are installing multiple readers with the RFID option, ensure a minimum of 25 cm (10 inches)
If you are installing multiple readers with the RFID option, ensure a minimum of 25 cm (10 inches)
between readers to prevent potential interference.
Unpack the Reader
Each reader package consists of:
Gemalto OEM Document Reader AT10Ki
Power supply unit (PSU) and AC cable
Test card
USB communication cable (Type C, USB3)
Micro fibre cloth
Power supply unit (PSU) and AC cable
Test card
USB communication cable (Type C, USB3)
Micro fibre cloth
Software download instructions
To unpack the reader:
1. Remove the contents from the box and separate the components from the packing material.
2. Verify that all the parts described have been received. If any parts are missing, contact Gemalto
Technical Services.
3. Keep and store the original packaging in the event that the reader requires shipment back to
Gemalto for maintenance.
Note: If the reader has been stored in a cold environment (i.e. below room temperature), allow the
reader warm up for a minimum two hours before powering it on.
reader warm up for a minimum two hours before powering it on.
DO NOT connect the reader to the computer until you have installed the software. See “Install the
software
software
” section below.