Geo Global Partners 001 Manual Do Utilizador

 

Description: Remote Control 

 ZHONGSHAN SKYISH ELECTROMOTOR & 

ELECTRICAL APPLIANCE CO., LTD. 
Address: NO.48, Industry Road(North), Xiaolan Town, Zhongshan City 

 Geo Global Partners 

Address: 1727 Old Okeechobee Blvd West Palm Beach, FL, 33409   

Working temperature: -10-50 ℃            Supply voltage: DC12-24V 
Product size: L130×W64×H24 mm        Net weight:145g         
Package size: L135×W72×H40mm        Gross weight:165g                                   

Output: Three CMOS drain- open output                                             
Connecting Mode: Common anode  √    cathode                                         
Max load current: 4 A  √    8A          each color 

 
 
 

Caution: 

The user is cautioned that changes or modifications 

not expressly approved by the party responsible for 
compliance could void the user's authority to operate the 
equipment. 
 
This device complies with Part 15 of the FCC Rules. 
Operation is subject to the following two conditions: (1) this 
device may not cause harmful interference, and (2) this 
device must accept any interference received, including 
interference that may cause undesired operation. 

NOTE: This equipment has been tested and found to comply 
with the limits for a Class B digital device, pursuant to Part 15 

of  the  FCC  Rules.  These  limits  are  designed  to  provide 
reasonable  protection  against  harmful  interference  in  a 
residential  installation.  This  equipment  generates,  uses  and 
can  radiate  radio  frequency  energy  and,  if  not  installed  and 
used in accordance with the instructions, may cause harmful 
interference  to  radio  communications.  However,  there  is  no 
guarantee  that  interference  will  not  occur  in  a  particular 
installation.   
If this equipment does cause harmful interference to radio or 
television reception, which can be determined by turning the 
equipment off and on, the user is encouraged to try to correct 
the interference by one or more of the following measures:   
-- Reorient or relocate the receiving antenna. 
--  Increase  the  separation  between  the  equipment  and 
receiver.   
-- Connect the equipment into an outlet on a circuit different 
from that to which the receiver is connected.   
--  Consult  the  dealer  or  an  experienced  radio/TV  technician 
for help 

IV .Panel specification and connecting drawing as   
follows: