HINEX MRO INDUSTRIES Limited HS-2018 Manual Do Utilizador
Page
12
6. Troubleshooting
Notes: This reference is only for professional technicians
Notes: This reference is only for professional technicians
Unusual Cases
Possible Reasons
Solution Steps
After installation, the P-
Tag is within detected
range, but alarm doesn’t
work.
Tag is within detected
range, but alarm doesn’t
work.
1. Lamp/speak cable not
connected well
1. Tighten all the cables
2. Power cable not connected well
2. Re-connect the power cable and
make sure it works well
3. Cable failure
3. Try another cable
4. Host failure
4. Try another host
5. P-tag low battery
5. Recharge the P-tag
6. P-tag failure
6. Try another P-tag
7. Host crash
7. Turn off the Host power cable
switch for 20 seconds before
restarting the power
restarting the power
8. P-tag cannot enter into dormant
status
8. Turn off the P-tag, wait for 3
seconds and then turn it on again.
After installation, the
alarm Flashing light (or
speaker) works but
audio speaker (or
Flashing light) doesn’t
work
alarm Flashing light (or
speaker) works but
audio speaker (or
Flashing light) doesn’t
work
1. Speaker (or Flashing light) cable
not connect well
1. Connect speaker (or Flash light)
cable
2. Cable failure
2. Try another cable
3. Speaker (or Flashing light)
failure
3. Try another speaker (or Flashing
light)
4. Host failure
4. Try another host