NEC Corporation of America KMP6J1T1 Manual Do Utilizador
2
.
,
If the SIM card is not fully inserted when the battery is replaced, damage to the SIM card can occur.
/
If the SIM card is already fitted, see “Start-up” on page 4.
Removing a SIM card
☛
With the battery removed, push the short and straight end of the SIM card with your thumb to
slide it gently in the direction of arrow
➆
➔
Lift the SIM card after it is completely removed from
the holder.
Charging the battery
Before trying to use your phone, insert the phone’s battery, connect the NEC battery charger (AC
adapter) supplied with your phone to a suitable mains power socket.
☛
Pull open the charger connector cover gently.
,
Be careful when handling the charger connector cover. Do not pull strongly.
☛
Connect the charger plug (AC adapter) into the charger connector at the bottom of the phone. If
your phone is turned on and charging starts, the battery icon will flash. LED will turn on in red
while charging. When charging is complete, the LED will turn off.
2
You are recommended to switch off the phone while charging. If you need to receive calls, your phone can be switched on and left in standby
while being charged, although the total time taken to charge is then increased.
The colour on the display shows the charging status of battery.
(red) Fast battery charging
(green) Slow battery charging while the phone is in use
(blue) Battery charging is stopped due to overheat
,
Using any battery pack, AC adapter, vehicle power adapter (option) not specified by NEC for use with this phone can be dangerous and
may invalidate any warranty and approval given to the cellphone. Do not leave the charger connected to the mains supply when it is not
in use.
,
Do not try to charge the battery if the ambient temperature is below 5°C (41°F) or above 35°C (95°F).
Rear cover
About 3 mm
Battery
Finger tab
Holder
SIM card
Notches
Tabs
About 3 mm
Check that there is no gap
between the rear cover
and the phone body.
Charger connector
Charger plug
Charger connector
cover