RadioShack Corporation 6301123 Manual Do Utilizador
©
2002 RadioShack Corporation.
All Rights Reserved.
RadioShack and RadioShack.com are trademarks
used by RadioShack Corporation.
63-1123
OWNER’S MANUAL — Please read before using this equipment.
Thank you for purchasing the RadioShack
Single Bell Wireless Door Chime. It works as
a doorbell, remote pager, or an alert. You
can add an optional external sensor to have
a chime that alerts you when someone
walks into a room. The door chime’s three-
position channel switch helps prevent other
transmitters or radio devices from sounding
the chime.
Single Bell Wireless Door Chime. It works as
a doorbell, remote pager, or an alert. You
can add an optional external sensor to have
a chime that alerts you when someone
walks into a room. The door chime’s three-
position channel switch helps prevent other
transmitters or radio devices from sounding
the chime.
/1706+0)"6*'"
64#05/+66'4"
1. Remove the transmitter from the holder.
2. Use the holder as a template to mark
two screw holes on the wall.
3. Remove the holder from the mounting
surface and drill two
3
/
16
inch diameter
holes. Insert one of the supplied
anchors into each hole.
anchors into each hole.
4. Drive a screw through the holder into
each hole.
5. The transmitter can be slid in and out of
the holder. To lock the transmitter, fix it
with a size M2.6 screw at the bottom of
the holder.
with a size M2.6 screw at the bottom of
the holder.
+056#..+0)"
$#66'4+'5"#0&"
5'.'%6+0)"%*#00'.5
The door chime requires three AAA batteries
in the transmitter and three C batteries in the
receiver. For best performance and longest
life, we recommend RadioShack alkaline
batteries.
in the transmitter and three C batteries in the
receiver. For best performance and longest
life, we recommend RadioShack alkaline
batteries.
.
.
.
.
+
0
"
6*'
"6
4#05/+66'4
1. Slide the transmitter's battery
compartment door in the direction of the
arrow to remove it.
arrow to remove it.
2. Use a small flat-blade screwdriver to
slide the switch inside the battery
compartment to the desired channel for
the transmitter.
compartment to the desired channel for
the transmitter.
3. Install three AAA batteries as indicated
by the polarity symbols (+ and –)
marked inside.
marked inside.
4. Replace the compartment door. If the
transmitter's LED indicator dims,
replace the batteries.
replace the batteries.
+
0
"
6*'
"4
'%'+8'4
1. Slide the receiver's battery
compartment door in the direction of the
arrow to remove it.
arrow to remove it.
2. Slide the switch inside the battery
compartment to select the same
channel for the receiver as is selected
for the transmitter.
channel for the receiver as is selected
for the transmitter.
±
3. Install three C batteries as indicated by
the polarity symbols (+ and –) marked
inside.
inside.
4. Replace the compartment door. If the
receiver's LED flashes with a short
beep tone, replace its batteries.
beep tone, replace its batteries.
#
"+/2146#06"
#
If an icon appears at the end of a paragraph,
go to the box on that page with the
corresponding icon for pertinent information.
go to the box on that page with the
corresponding icon for pertinent information.
Rý
— Warning
°
°
°
°
— Hint
.
.
.
.
— Caution
±
— Note
#
— Important
Receiver
Transmitter
Slide ON/OFF to ON
so that when BELL
is pressed on the
transmitter, a door
chime sounds.
so that when BELL
is pressed on the
transmitter, a door
chime sounds.
BELL — Press BELL
to hear the door
chime.
to hear the door
chime.
Indicator — Lights when
BELL is pressed.
BELL is pressed.
.
"%#76+10"
.
• Use only fresh batteries of the required size
and type. Always remove old or weak
batteries. They can leak chemicals that
destroy electronic circuits
batteries. They can leak chemicals that
destroy electronic circuits
• Do not mix old and new batteries, different
types of batteries (standard, alkaline, or
rechargeable), or rechargeable batteries of
different capacities.
rechargeable), or rechargeable batteries of
different capacities.
.
"%#76+10"
.
• Use only fresh batteries of the required size
and type. Always remove old or weak
batteries. They can leak chemicals that
destroy electronic circuits
batteries. They can leak chemicals that
destroy electronic circuits
• Do not mix old and new batteries, different
types of batteries (standard, alkaline, or
rechargeable), or rechargeable batteries of
different capacities.
rechargeable), or rechargeable batteries of
different capacities.
±
"016'"
±
"
The channel settings must be the same for the
transmitter and the receiver. If the door chime
occasionally sounds without anyone pressing
BELL, change the channel settings for both
the transmitter and receiver.
transmitter and the receiver. If the door chime
occasionally sounds without anyone pressing
BELL, change the channel settings for both
the transmitter and receiver.
5KPING"$GNN"9KTGNGUU"&QQT"%JKOG
63-1123.fm Page 1 Thursday, June 6, 2002 12:41 PM