Furuno USA Inc 9ZWFA150 Manual Do Utilizador
1. OPERATION
1-2
1.2
Turning the Power On and Off
Press the [PWR] key to turn the equipment on or off. When powered, the
equipment sounds a beep for several seconds and then proceeds in the
sequence shown below.
equipment sounds a beep for several seconds and then proceeds in the
sequence shown below.
[STARTUP TEST]
PROGRAM No.:
2450021-**.**
ROM
PROGRAM No.:
2450021-**.**
ROM
: OK
RAM
: OK
BACKUP DATA
: OK
**.**: Program Version No.
A
UTOMATIC
I
DENTIFICATION
S
YSTEM
FURUNO ELECTRIC CORP.
EQUIPMENT IDENTIFICATION
SCREEN
SCREEN
STARTUP SCREEN
[- - - - - - - -]
HDG: - - -
HDG: - - -
°
SOG: - - .-kt
COG: - - -.-
CPA: - - -.-
TCPA: - -'- -"
INTRD: 0
COG: - - -.-
CPA: - - -.-
TCPA: - -'- -"
INTRD: 0
RNG: 6 DETAIL:[ENT]
n
m
n
m
NOW INITIALIZING
PLOTTER DISPLAY
Startup sequence
The startup screen displays the program version number and the results of the
ROM, RAM and backup data test, showing OK or “NG” (No Good) as the result.
If “NG” (No Good) appears for any of the check results, try resetting the power
to restore normal operation. If that does not work, contact your dealer for
advice. After the startup test is completed the plotter display appears, showing
the message “NOW INITIALIZING,” which means the transponder is initializing
itself. After completion of initialization the equipment is ready for use.
If there is no response from the transponder unit, the message
“COMMUNICATION ERROR” appears at the startup screen. Press any key to
erase the message. Check if the transponder unit is powered. Also check the
connection between the monitor unit and the transponder unit.
ROM, RAM and backup data test, showing OK or “NG” (No Good) as the result.
If “NG” (No Good) appears for any of the check results, try resetting the power
to restore normal operation. If that does not work, contact your dealer for
advice. After the startup test is completed the plotter display appears, showing
the message “NOW INITIALIZING,” which means the transponder is initializing
itself. After completion of initialization the equipment is ready for use.
If there is no response from the transponder unit, the message
“COMMUNICATION ERROR” appears at the startup screen. Press any key to
erase the message. Check if the transponder unit is powered. Also check the
connection between the monitor unit and the transponder unit.