Furuno USA Inc 9ZWRTR112 Manual Do Utilizador
1. INSTALLATION AND WIRING
11
3. Wrap the junction of the connectors with self-vulcanizing tape and vinyl tape (lo-
cally supply) for waterproofing as follows:
4. As shown in the figure below, attach a ground wire (IV-2sq, local supply) between
the ship’s ground and the screw on the cable cover of the antenna unit.
5. Apply the silicone rubber about ground point of the ship’s ground.
Self-vulcanizing tape
1) Wrap the junction of the connectors
with one layer of self-vulcanizing
tape.
tape.
2) Change wrap direction and wrap
one layer of the self-vulcanizing
tape again.
tape again.
Self-vulcanizing tape
3) Wrap one layer of the vinyl tape over
the self-vulcanizing tape.
Vinyl tape
4) Change wrap direction and wrap one
layer of the vinyl tape again.
Vinyl tape
Ship’s ground
Terminal screw*
Ground wire from
the ship’s ground
the ship’s ground
Ground wire* from
the antenna unit
the antenna unit
*: Pre-attached to the cable cover.
Cable cover
Weld here.
Hex. bolt
Flat washer
Flat washer
Spring washer
Hex. nut
OR
Hex. nut
Hex. nut
Spring washer
Flat washer
Ground wire
Ground wire
Silecone rubber
Ground point
Weld here.