SANYO Electric Co. Ltd. SCP-4930 Manual Do Utilizador

Turning Your Phone On
To turn your phone on:
Press and hold 

E for approximately 2 seconds.

Once your phone is on, it may display “Looking for Service...,” which indicates that
your phone is searching for a signal. When your phone finds a signal, it automatically
enters standby mode – the phone’s idle state. At this point, you are ready to begin
making and receiving calls.
If your phone is unable to find a signal after 15 minutes of searching, a Power Save
feature is automatically activated. When a signal is found, your phone automatically
returns to standby mode.
In Power Save mode, your phone searches for a signal periodically without your
intervention. You can also initiate a search for PCS Service by pressing any key (when
your phone is turned on).

Turning Your Phone Off
To turn your phone off:
Press and hold 

E for two seconds until you see the powering down animation on the

display screen.
Your screen remains blank while your phone is off (unless the battery is charging).

To unlock your phone, follow these easy steps:
1. Press and hold 

E to turn the phone on.

2. Press Unlock (left softkey).

3. Enter your four-digit lock code. (For security purposes, the code is not visible as

you type.)

Note: To select a softkey, press the softkey button directly below the softkey text
that appears at the bottom left and bottom right of your phone’s display screen.
Softkey actions change according to the screen you’re viewing and will not appear if
there is no corresponding action available.

Tip: The Power Save feature helps to conserve your battery power when you are in
an area where there is no signal.

10