ICOM 297000 Manual Do Utilizador
III
QUICK REFERENCE GUIDE
D Using the mounting bracket
q Drill 4 holes where the mounting bracket is to be installed.
• Approx. 5.5–6 mm (
1
⁄
4
″) when using nuts; approx. 2–3 mm (
1
⁄
8
″)
when using self-tapping screws.
w Insert the supplied screws, nuts and washers through the
mounting bracket and tighten.
e Adjust the angle for your suitable position.
D Controller/Separation cable connection
Two connection cables, conteoller cable
(10 cm; 3.9 in)
for sin-
gle body installation and separation cable
(3.4 m; 11.2 ft) for re-
mote installation,
are supplied with the IC-2820H.
Connect the controller and the main unit using with the sup-
plied connection cable as follows.
plied connection cable as follows.
IMPORTANT!— number of pin
Number of pin, between both side connectors of the connec-
tion cable are different— one side is 6-pin, other side is 4-pin.
You should connect the 6-pin connector to the main unit, and
the 4-pin connector to the controller.
Number of pin, between both side connectors of the connec-
tion cable are different— one side is 6-pin, other side is 4-pin.
You should connect the 6-pin connector to the main unit, and
the 4-pin connector to the controller.
Controller
Main unit
6-pin connector
4-pin connector
Nut
Spring washer
When using
self-tapping
screws
self-tapping
screws
Flat washer
Mounting nut
Mounting
bracket
bracket
25˚