ICOM 301500 Manual Do Utilizador

66

8

SCAN OPERATION

N Programmed scan operation (VFO mode)

Programmed scan searches for signals between 
scan edge memory channels P1 and P2.
The default frequencies for these memories are 
0.500000 MHz and 29.99999 MHz, respectively.
See p. 62 for scan edges programming.

q Push 

V/M 

 to select VFO mode.

w  Push 

 to select the desired operating 

mode.

 

• The operating mode can be changed while scanning.

e Push 

 to select a tuning step.

 

• The tuning step can be changed while scanning.

r Set the [RF/SQL] control open or closed.

 

• See the left page for squelch condition.

 • 

 

If the [RF/SQL] control function is set as “AUTO,” 
the squelch is always open in SSB, CW and RTTY 
modes. See pgs. 4, 30, 75 for details.

t  Push 

 to start the scan.

 • 

“

” appears while scanning.

y  When the scan detects a signal, the scan turns 

OFF, pauses or ignores it depending on the 
resume setting and the squelch condition.

u To cancel the scan, push 

.

 NOTE: If the same frequencies are programmed 
into both scan edge memory channels P1 and P2, 
programmed scan does not start.

Appears

N Memory scan operation (Memory mode)

Memory scan searches through memory channel  
1 to 199 for signals. Blank (unprogrammed) memory 
channels are skipped.

q  Push 

V/M 

 to select memory mode.

w Close the squelch with the [RF/SQL] control.
e  Push 

 to start the scan.

 • 

“

” appears while scanning.

r  When the scan detects a signal, the scan stops or 

pauses depending on the resume setting.

t To cancel the scan push 

.

 • 

 

Rotating  [DIAL] during scan also cancels scan 
operation.

 NOTE: Two or more memory channels must be 
programmed for memory scan to start.

Appears