ICOM 382200 Manual Do Utilizador

64

13

You cannot turn ON the 
transceiver.

 

•

 The Battery is exhausted or over 
discharged.

 

• The Battery pack is not correctly attached.

 

•  Recharge the battery pack.

 

•

Correctly attach the battery pack.

p. 61

p. 2

Little or no sound 
comes from the 
speaker.

 

• The squelch level is set too high.

 

• The volume level is set too low.

 

•

The speaker has been exposed to water.

 

•  Water has entered to the speaker 

microphone connector.

 

• Set the squelch to the threshold point.

 

• Set the volume to a suitable level.

 

•

 Remove the water using the AquaQuake 
function.

 

• Dry the speaker microphone connector.

p. 13

p. 15

–

You cannot transmit

 

•  Some channels are preset for low power 

or receive only by regulations.

 

•

The battery is exhausted.

 

• The battery is overcharged.

 

• The output power is set to low.

 

•

Change channels.

 

•  Recharge the battery pack.

 

•

 Conirm that the battery voltage is correct.

 

•  Push the software key below 

 to select 

high power.

p. 14 

p. 61

p. 5

Scan does not start

 

•

Favorite channels are not set.

 

•

 Set the Favorite channels.

p. 17

No beeps sound

 

•

Key Beep is set to OFF.

 

•

 Turn ON the Key Beep on the 

“Coniguration” screen.

p. 57

You cannot send DSC 
calls

 

•

  MMSI (DSC self ID) code is not entered.

 

•

DSC Switch is set to OFF.

 

•

 Enter the MMSI (DSC self ID) code.

 

•

Turn ON the DSC Switch in the Menu.

p. 9

p. 42

You cannot receive 

GPS position data

 

•

 The built-in GPS antenna is obstructed, 

which interrupts the GPS signals from the 
satellites.

 

•

 Use the transceiver in a place where 
nothing interrupts the satellite signal.

–