ICOM 384602 Manual Do Utilizador

– 4 –

– 1 –

Thank you for choosing this Icom product.

READ ALL PRECAUTIONS carefully and completely 

before using this product.

1-1-32 Kamiminami, Hirano-ku, Osaka 547-0003, Japan

A-7383D-2EX 

Printed in Japan

 

© 2017  Icom Inc.

PRECAUTIONS

VHF P25 TRANSCEIVER

Iç-F7520

UHF P25 TRANSCEIVER

Iç-F7510

R

Personal death, serious injury or an explosion may occur.

R

Personal injury, fire hazard or electric shock may occur.

Equipment damage may occur.

If disregarded, inconvenience only. No risk of personal injury, fire or electric shock.

R

WARNING! NEVER connect the transceiver to an AC 

outlet. This may pose a fire hazard or result in an electric 

shock.

R

WARNING! NEVER operate the transceiver during a 

lightning storm. It may result in an electric shock, cause a 

fire or damage the transceiver. Always disconnect the power 

souce and antenna before a storm.

R

WARNING! NEVER connect the transceiver to a power 

source of more than 16 V DC such as a 24 V battery. This 

could damage the transceiver.

R

WARNING! NEVER cut the DC power cable between the 

DC plug and fuse holder. If an incorrect connection is made 

after cutting, the transceiver might be damaged.

R

WARNING! NEVER place the transceiver where normal 

operation of the vehicle may be hindered or where it could 

cause bodily injury.
CAUTION: NEVER expose the transceiver to rain, snow or 

any liquids.
CAUTION: CONFIRM that all connectors and jacks are 

dry and clean before attachment. Exposing them to dust or 

water will result in serious damage to the transceiver.
DO NOT place or leave the transceiver in areas with 

temperatures below –30°C (–22°F) or above +60°C 

(+140°F), or in areas subject to direct sunlight, such as the 

dashboard.

DO NOT operate the transceiver without running the 

vehicle’s engine. The vehicle’s battery will quickly run out 

when the transceiver transmits while the vehicle’s engine is 

OFF.
DO NOT place or leave the transceiver in excessively dusty 

environments.
DO NOT place the transceiver against walls. Otherwise 

heat dissipation will be obstructed.
DO NOT use harsh solvents such as Benzine or alcohol 

when cleaning, as they damage the transceiver’s surfaces.
BE CAREFUL! The transceiver will become hot when 

operating continuously for long periods.
USE the specified microphone only. Other microphones 

have different pin assignments and may damage the radio.
Place the radio in a secure place to avoid inadvertent use 

by unauthorized persons.
This transceiver has an air vent on the bottom panel of the 

transceiver to meet the IP55 requirements.
BE CAREFUL! DO NOT block the air vent when installing 

the transceiver.

Icom is not responsible for the destruction or damage to 

the Icom transceiver, if the malfunction is because of:

 • Force majeure, including, but not limited to, fires, 

earthquakes, storms, floods, lightning, other natural 

disasters, disturbances, riots, war, or radioactive 

contamination.

 • The use of Icom transceivers with any equipment that is 

not manufactured or approved by Icom.