ICOM ic-2720h Manual Do Utilizador

29

New2001

5

■ General description

The transceiver has 212 memory channels including 10 scan
edge memory channels (5 pairs), and 2 call channels. Each of
these channels can be individually programmed with operating
frequency (pgs. 11–13), duplex direction (p. 23) and offset
(p. 27), subaudible tone encoder or tone squelch and its tone
frequency (pgs. 23, 25, 52, 53) and skip information* (p. 44). 
In addition, a total of 10 memory banks, A to J, are available
for usage by group, etc.

*except for scan edge memory channels.

■ Memory channel selection

D Using the tuning dial

q Push the desired band’s

[M/CALL(MW)] several
times to select memory
mode.

• “M” indicator appears

w Rotate the same band’s

[DIAL] to select the de-
sired memory channel.

• Programmed memory

channels only can be se-
lected.

D Using the [Y]/[Z] keys

z Push [BAND] to select the desired band as

the main band.

x Push [MR/CALL] to select memory mode.
c Push [Y] or [Z] to select and set the desired

memory channel.

• Pushing [Y]/[Z] for 1 sec. activates a scan.
• If scan is activated, push [Y]/[Z] again or push

[

CLR

A(MW)] to stop it.

D Using the keypad

z Push [BAND] to select the desired band as

the main band.

x Push [MR/CALL] to select memory mode.
c Push [

ENT

C(T-OFF)] to activate the keypad

for numeral input.

v Push 3 appropriate digit keys to input a chan-

nel number. 

• Blank channel can be selected.
• Push only 1 appropriate digit key, [

MONI

1(BANK)],

[

SCAN

2(T-SCAN)], [

PRIO

3(PTT-M)],

[

HIGH

4(DTCS)] or [

MID

5(DTCSS)] then push

[M

M(TONE-1)] or [

SQLZ

#(16KEY-L)] to select scan

edge channels. “M

M” and “#” can be used for “A”

and “b” respectively.

MR/CALL

Y/Z

MR/CALL

Y/Z

Push [M/CALL•MW] to select
memory mode.

“M” appears

IC-2720H.qxd  02.9.9 8:12  Page 29 (1,1)