Nilfisk-advance Inc. ME401 Manual Do Utilizador
ME401-9
Nilfisk Advance ME401-9, Technical Manual v1.2, Marts 2014
Page 10
Installing the unit
Practical installation advice
• It is very important to be careful when installing the unit, as incorrect
installation will reduce the quality of the GPS position reports (Ex. could be a
jump in position or showing speed while parking) or in the worst case
scenario will prevent the unit performing any position reporting at all.
jump in position or showing speed while parking) or in the worst case
scenario will prevent the unit performing any position reporting at all.
.
•
The unit must be mounted either horizontally or vertically (sideways) using either
screws or strips. The unit
screws or strips. The unit
must not be installed with the interface/supply cable
hanging down, as this definitely will reduce the GPS sensitivity.
Optimize the placement of the unit to increase the aerial view (through windows
etc.) as much as possible. For hiding the unit, make sure it is only mounted beneath
plastic parts or similar parts (wood), but not beneath metal parts.
Optimize the placement of the unit to increase the aerial view (through windows
etc.) as much as possible. For hiding the unit, make sure it is only mounted beneath
plastic parts or similar parts (wood), but not beneath metal parts.
•
To reduce hum and noise in the FM radio it is recommended to place the unit at a
minimum distance of 20 inches (50 cm) from the radio or the loudspeakers.
minimum distance of 20 inches (50 cm) from the radio or the loudspeakers.
Connections
The connections depend on the type of vehicles / machines etc. in which the GSM/GPS
unit is to be installed. In the table below the possible connections are listed for the ME401-
9 device.
The connections may differ for other variants of the ME401-9 device. Please contact your
nearest sales office, distributor or “Reseller” for further information about the availability of
other variants in your area.
unit is to be installed. In the table below the possible connections are listed for the ME401-
9 device.
The connections may differ for other variants of the ME401-9 device. Please contact your
nearest sales office, distributor or “Reseller” for further information about the availability of
other variants in your area.
Wire
(color code)
ME401-9 function
Red
Supply voltage +12 to +48 V
White
Digital input 1
Brown
Digital input 2 Ignition
Grey
Digital input 3
Pink
Digital input 4
Green
1-Wire input
Yellow
Digital output 1
Blue
Common ground
The unit must NOT be installed beneath metal plates or inside
closed metal compartments. Incorrect installation will also
reduce the standby time of the battery inside the unit.