CBF Networks Inc. dba Fastback Networks 105 Manual Do Utilizador
IBR Installation Guide
Page 21 of 38
Doc # 770-00023.1
Jan. 23, 2015
Packets
TX queue packets
MCS counters can be displayed using the following command:
IBR102 # show interfaces radio 0 status
Counters can be cleared using the following commands:
IBR102 # clear counters mcs
clears mcs counters
IBR102 # clear counters radio
clears radio counters
IBR102 # clear counters switch
clears counters on all switch interfaces
IBR102 # clear counters gigabitEthernet [arg]
arg can be 0, 1, 2, or 3
6.
Installing IBR
6.1 Safety Considerations
Ensure that grounding is in accordance with local codes. IBR should be grounded using the ground lug
connector on the back of IBR with a lug such as Panduit Two-Hole Standard Barrel Copper Lug, Panduit
part #LCD6-14A-L (shown below). Note that since the grounding lug mounts between the fins, any lug
greater than 0.48 inches in width will not fit.
connector on the back of IBR with a lug such as Panduit Two-Hole Standard Barrel Copper Lug, Panduit
part #LCD6-14A-L (shown below). Note that since the grounding lug mounts between the fins, any lug
greater than 0.48 inches in width will not fit.
Use overhead work methods and/or equipment that are appropriate for the location; e.g., climbing
equipment, ladder, man lift, etc.
equipment, ladder, man lift, etc.
Note the locations of other equipment, power lines, vehicle traffic, and other potential safety hazards at
the installation site.
the installation site.
6.2 Installation Checklist for one end of a link
6
A pretested and preconfigured IBR.
IBR mounting brackets.
A PoE
+
source capable of supplying at least thirty-five (35) watts total on two pairs (pins 4&5 and 7&8)
or on all four pairs.
A surge suppressor that has been validated to function properly with IBR, such as Transector Model T-
419899.
419899.
Materials for grounding IBR:
6
A link will require a matching pair of IBRs; e.g., IBR101 and IBR102.