FN-LINK TECHNOLOGY LIMITED F11AUUM13 Manual Do Utilizador

FN-LINK TECHNOLOGY LIMITED

Page 9 /9

IC Notice:
This device complies with Canada Industry licence-exempt RSS standard(s).
Operation is subject to the following two conditions: (1) this device may not
cause interference. and (2) this device must accept any interference. Including
interference that may cause undesired operation of the device.
CAN ICES-3 (B)
Le présent appareil est conforme aux CNR d'industrie Canada applicables aux
appareils radio exem pts de licence L'exploitation est autorisée aux deux
conditions suivantes:
1) I'appareil ne doit pas produire de brouillage, et
2) I'utillsateur de I'appareil doit accepterbrouillage radioélectrique subi meme
si le brouillage est susceptible d'encompromettre le fonctionnement. mauvais
fonctionnement de I'appareil.
NMB-3 (B)

FCC Radiation Exposure Statement:

This modular complies with FCC RF radiation exposure limits set forth for an uncontrolled environment. 

This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.

Due to missing shielding the module is strictly limited to integration by the Grantee himself or his dedicated  

OEM integrator under control of the Grantee.However, the OEM integrator is still responsible for testing  

their end-product for any additional compliance requirements required with this module installed.

This device is intended only for OEM integrators under the following conditions:

1)This module is granted as a Limited Modular Approval.

2)This device has been designed to operate with a integral antenna having a maximum gain of 0dBi.Only  

this type of antenna may be used.

 

 

 This device has been evaluated and shown compliant with the FCC RF Exposure  limits under fixed  

exposure conditions (antennas are greater than 20cm from a person’s body)when installed in certain 

specific OEM configurations. 

 

The host system shall have a label showing: Contains FCC ID:2AATL-F11AUUM13  

The wifi module is designed to comply with the FCC statement. FCC ID is 2AATL-F11AUUM13. The host 

system using wifi module F11AUUM13-W3,  F11AUUM13-W2,  should have label indicated  FCC ID  

Note: The wifi module has no shielding and tested stand alone.

antenna that users can be use: FPC antenna, PCB antenna, integral antenna.

This module is tested and approved as Limited modular approval with stand alone configuration, any OEM 

incorporated this radio module into any system may require additional testing and evaluation.

(The gain of antenna : -2 to 0dBi)

This module is not sales with antenna, it requires the OEM to complete the antenna. And the kind of 

2AATL-F11AUUM13. 

F11AUUM13-W2

 

USB WIFI 

Module 

Pin 2 

Antenna 

(Kind of antenna: FPC antenna, PCB 

antenna, Integral antenna

)