LUMI LEGEND ELECTRICAL CO. LTD SD5001 Manual Do Utilizador
1 2 3 4
PS: Please change the code if you encounter interference with another socket.
D. Operation:
1
.
Adjust the code of both transmitter and receiver so that they are using the same code.
2
.
Adjust the channel of the receiver to the corresponding channel of the transmitter.
3
.
Plug your electrical appliance into a receiver socket. Then plug the receiver into the AC socket.
4
.
Press the corresponding channel on the remote control. Press the “ON” button and the socket
will turn on and the LED will illuminate. Press the “OFF” button and the socket will switch off
and the LED light will go off.
E. Specifications:
1. Transmitter battery: 12V/23A
2. Transmitter radio frequency: 433.92MHz
3. Receiver voltage: 120V / 60Hz / IP20/15A
4. Receiver maximum wattage: 1800W
5. Transmittion range: Typically 30m (clear line of sight)
WEEE Directive & Product Disposal
At the end of its serviceable life, this product should not be treated as household or
general waste. It should be handed over to the applicable collection point for the
recycling of electrical and electronic equipment, or returned to the supplier for
disposal
Internal / Supplied Batteries
This symbol on the battery indicates that the battery is to be collected separately.
This battery is designed for separate collection at an appropriate collection point.
F .Caution
This device complies with Part 15 of the FCC. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
Changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to operate the
equipment.
This equipment has been tested and found to comply with the limits for
a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates
This device complies with Part 15 of the FCC. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
Changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to operate the
equipment.
This equipment has been tested and found to comply with the limits for
a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates