Wintop Electronics Co. Limited WM-287 Manual Do Utilizador
Step 1. Open the back cover.
Step 3. Replace back cover.
Installing Battery
The Ultrathin Wireless mouse uses one AA battery .
Installing Battery in the Mouse:
Step 2. Insert the battery as shown inside the battery compartment.
Connecting the Receiver
USB Port
1. Connect the nano receiver ONLY to a USB port on your computer.
Model: WM-287
Instruction Manual
Nano receiver
Please read these instructions carefully before
first use and retain them for future reference.
Specifications:
1. The Nano Receiver is stored inside the mouse, in the battery compartment.
To remove the receiver, open your battery compartment and remove the receiver
as per step 1.
To remove the receiver, open your battery compartment and remove the receiver
as per step 1.
2. Once you have finished using the mouse, remove the receiver from your USB port
and replace within the mouse housing as per step 2.
and replace within the mouse housing as per step 2.
1
2
Remove the Receiver
Store the Receiver
Storing the Nano Receiver
110*57*23MM
Mac OS
0
The Ultrathin Wireless mouse
The Ultrathin Wireless mouse
FCC STATEMENT :
This device complies with Part 15 of the FCC Rules. Operation is subject
to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including
interference that may cause undesired operation.
Warning: Changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to operate the
equipment.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses
and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.