Apacer AP-AL720-500G Manual Do Utilizador
35
Chapter 14 Troubleshooting
Problem
Possible Cause
Solution
TV screen does not
display normally.
◎ Video setting is not correct.
◎ Press the TV SYSTEM button to
switch output TV system.
◎ Ensure that HDMI/AV/YPbPr
cable is properly connected to
the correct port on both TV and
media player
.
◎ When using HDMI cable to
connect TV, please choose
“1080P“ option, If your TV could
support 1080P.
◎ When using component video
cable, please choose
“720P“option.
◎ Once you choose 720P or
1080P option to setup TV
system, then use composite AV
cable to connect CRT TV. You
maybe see unclear images,
please press “TV SYSTEM”
button on the remote control to
set option among PAL; NTSC or
480p resolution.
No power.
(All LEDs are off)
◎ The power plug is not properly
connected.
◎ Check the power connection
and plug it again.
LED light up but
operation failure on
the media player.
◎ If the LED is Red, Press the
“Power“ button on the remove
control. If the LED doesn’t light
up from red to blue, please
contact the Apacer service
center
.
Can’t operate with
the remote control.
◎ If this device cannot be
activated by pressing
button of remote control, it is
probably because the power is
off.
◎ Remote control is not pointing
◎ Refer to “Power Connection”
section for its solution.
◎ Point the remote control toward