Lyve Minds Inc. HAN Manual Do Utilizador
FCC Regulations:
§ 15.19 (a)(3)
This device complies with part 15 of the FCC Rules. Operation is subject
to the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
§ 15.21
Changes or modifications not expressly approved by the party
responsible for compliance could void the user‘s authority to operate the
equipment.
§ 15.105 (b)
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged
to try to correct the interference by one or more of the following
measures:
•Reorient or relocate the receiving antenna.
•Increase the separation between the equipment and receiver.
•Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
•Consult the dealer or an experienced radio/TV technician for help.
§ 15.407 (e)
Operation on the 5.15-5.25 GHz frequency band is restricted to indoor
use only. The FCC requires indoor use for the 5.15-5.25 GHz band to
reduce the potential for harmful interference to co-channel Mobile
Satellite Systems.
FCC RF Exposure Compliance
This equipment complies with radio frequency (RF) exposure limits
adopted by the Federal Communications Commission for an uncontrolled
environment. This equipment should be installed and operated with
minimum distance 20 cm between the radiator & your body.
IC Regulations:
This device complies with Industry Canada license-exempt RSS
standard(s). Operation is subject to the following two conditions:
(1) this device may not cause interference, and
(2) this device must accept any interference, including interference that
may cause undesired operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables
aux appareils radio exempts de licence. L'exploitation est autorisée aux
deux conditions suivantes:
(1) l'appareil ne doit pas produire de brouillage, et
(2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique
subi, même si le brouillage est susceptible d'en compromettre le
fonctionnement."
CAN ICES-3(B)/NMB-3(B)
The device could automatically discontinue transmission in case of
absence of information to transmit, or operational failure. Note that this is
not intended to prohibit transmission of control or signaling information
or the use of repetitive codes where required by the technology.
•The device for operation in the band 5150–5250 MHz is only for indoor
use to reduce the potential for harmful interference to co-channel mobile
satellite systems;
•The maximum antenna gain permitted for devices in the bands
5250–5350 MHz and 5470–5725 MHz shall comply with the e.i.r.p. limit;
and
•The maximum antenna gain permitted for devices in the band
5725–5825 MHz shall comply with the e.i.r.p. limits specified for
point-to-point and non point-to-point operation as appropriate.
In addition, high-power radars are allocated as primary users (i.e. priority
users) of the bands 5250–5350 MHz and 5650–5850 MHz and that these
radars could cause interference and/or damage to LE-LAN devices.
IC RF Exposure Compliance
This equipment complies with IC RSS-102 RF exposure limits set forth for
an uncontrolled environment. This equipment should be installed and
operated with minimum distance 20 cm between the radiator & your
body.
Déclaration d'exposition aux radiations:
Cet équipement est conforme aux limites d'exposition aux rayonnements
IC établies pour un environnement non contrôlé. Cet équipement doit
être installé et utilisé avec un minimum de 20 cm de distance entre la
source de rayonnement et votre corps.
Product Information Guide
510-00012-000
Lyve Studio Product Information Guide
Rev-01
Sept 26, 2014
Created by: Jon Norton
Front
Back
Lyve Studio: Product Information Guide (PIG)
Finished Size: 63.1mm x 107.16mm
Finished Size: 63.1mm x 107.16mm
Type: Black
Paper Spec: TBD
Type: Alright Sans
63.1mm
107.16mm