NFTZ Hangpack Int'l Trading Co. Ltd. AMAX Manual Do Utilizador
7
Draft 1.3
FCC Notice
■This device complies with Part 15 of the FCC Rules. Operation is subject to the
followin g two conditions: (1) this device may not cause harmful interference, and (2)
this device must accept any interference received, including interference that may
cause undesired operation.
■The manufacturer is not responsible for any radio or TV interference caused by
unauthorized modifications to this equipment. Such modifications could void the
user’s authority to operate the equipment.
■This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses, and can radiate radio frequency energy, and if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment OFF and ON, the user is
encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
Industry Canada Notice
■This device complies with industry Canada license‐exempt RSS standards(s).
Operation is subject to the following two conditions: (1)this device may not cause
interference,and (2)this device must accept any interference , including
interferernce that may cause undesired operation of the device.
■Le présent appareil est conforme aux CNR d’lndustrie Canada applicables aux
appareils radio exempts de licence. L’exploitation est autorisée aux deux
conditions suivantes: (1) I’appareil ne doit pas produire de brouillage, et (2)
I’utilisateur de I’appareil doit accepter tout brouillage radioélectrique subi, même
si le brouillage est susceptible d’en compromettre le fonctionnement.
■Under industry Canada regulations,this radio transmitter may only operate using
an antenna of a type and maximum(or lesser)gain approved for the transmitter by
industry Canada. To reduce potential radio interference to other users,the
antenna type and its gain should be so chosen that the equivalent isotropically
radiated power (e.i.r.p.) is not more than that necessary for successful
communication. Conformément à la réglementation d’lndustrie Canada, le
présent émetteur radio peut fonctionner avec une antenne d’un type et d’un gain
maximal (ouinférieur) approuvé pour l’ émetteur par Industrie Canada. Dans le
but de réduire les risques de brouillage radioélectrique à l’intention des autres
utilisateurs, il faut choisir le type d’antenne et son gain de sorte que la puissance
isotrope rayonnée équivalente (p.i.r.e.) ne dépasse pas l’intensité nécessaire à l’
établissement d’une communication satisfaisante.