SHANGHAI ETIGER DIGITAL TECHNOLOGY CO. LTD. ES-D3A Manual Do Utilizador

Box Content

1 x Door / Window Contact

1 x User Manual

Transmitter

Magnet

www.etiger.com

ES-D3A

Wireless Door / Window Contact

PCB Layout

LED working indicator

Jumpers for zone setup

A23 12V Battery

Tamper switch

Infrared sensor: Detects the infrared rays released by human body

motion. Do not touch the surface. Keep the surface clean.

Tamper switch: When the alarm system is armed, the tamper switch

will trigger the alarm if the case is opened.

Jumpers for Zone setup: The jumpers enable you to assign the

detector to a specific zone. Refer to the user manual of your alarm

system for more information on zone set up.

Standards

This product bears the selective sorting symbol for waste electrical

and electronic equipment (WEEE). This means that this product must

be handled pursuant to European Directive 2002/96/EC in order to be

recycled or dismantled to minimize its impact on the environment. For

further information, please contact your local or regional authorities.

Electronic products not included in the selective sorting process are

potentially dangerous for the environment and human health due to

the presence of hazardous substances.

In compliance with European laws.

This product was designed and manufactured in compliance with

Directive 2002/95/EC of the European Parliament and of the Council on

the restriction of use of certain hazardous substances in electrical and

electronic equipment (RoHS Directive - RoHS) and is deemed to comply

with the maximum concentration values set by the European Technical

Adaptation Committee (TAC).

Manufactured in China.

Images, illustrations and text are non-contractual. ETIGER and the ETIGER logo are

registered trademarks and the property of ETIGER.

Installation

Open the case and remove the battery activation strip.

Mount the sensor on the door and the magnet on the door frame.

Make sure the magnet is placed above of the transmitter.

Mount the magnet max. 1cm away from the transmitter and secure the

transmitter and magnet with double-sided tape or screws.

Avoid mounting the sensor in areas with a large amount of metal or

electrical wiring, such as a furnace or utility room.

Register the detector in the alarm system

Switch to Connection Mode on the control panel. Separate the magnet

of the detector from its transmitter. The control panel beeps once: the

detector is registered. If you hear two beeps, the detector has already

been connected.

To check if the registration

is complete, arm the system

and separate the magnet

from the transmitter again

by opening the door or

window on which it is

installed. If the siren rings

out, the registration is

successful.

Specifications

Power Supply:

DC 12V (A23 12V battery x1)

Static current:

≤30 uA

Alarm current:

≤40 mA

Transmission distance

≤ 80 m (in open area)

Radio-frequency:

315MHz (±75KHz)

Housing material:

ABS plastic

Operating conditions:

Temperature: -10°C ~ +55°C

Relative Humidity: ≤80% (non-con-

densing)

Transmitter dimensions:

60 x 43 x 18 mm

Magnet dimensions:

19 x 43 x 18 mm

LED indications

Blinks once

The door or window is open and the transmitter sends a signal to the

control panel.

Blinks quickly

Low power indication: the batteries must be replaced.

ETIGER EUROPE

Rue de la Loi, 25, 7100 La Louvière, Belgique

service@etiger.com

This user manual is available in other languages at

www.etiger.com/eu/support

-D3A

-UM

-EN20140724:2.0-