Honeywell MCR5532C Manual Do Utilizador
Honeywell
1 / 2
Contactless Smart Card Reader
Installation Instructions
Model:
JT-MCR45(55)-32C
Rev 1.3, Apr.18th, 2014
WHAT IS THE Contactless Smart Card Reader?
The Reader is an RFID Contactless Smart Card reader for use with
access control systems.
These installation instructions contain the following information:
Mounting Instructions
Connecting the reader to a host using the wiegand interface
Testing and operation of the reader
How to install the PSAM card?
If the card reader is configured as software encrypted, it is no need
the PSAM card. But if it is hardware encrypted, the PASM card is
necessary. The steps to install the PSAM card are as follow:
1.
Open the back cover of the reader first and then you could
find the socket of PSAM card.
2.
Push the deck lid on the socket in the direction of sign
“OPEN”, and then open it.
3.
Insert the flat side of PASM card (NOT THE SIDE WHICH
HAS MISSING CORNER) alone the guide groove on the
upper lid. Let the face which has contacts up (THIS SIDE
WILL FACE DOWN AFTER CLOSE THE LID). After that,
close the upper lid and push it in the opposite direction when
open it, make sure the lid be locked and fastened reliably.
4.
Close the back cover of the card reader.
HOW TO MOUNT THE READER
To surface mount the reader, perform the following:
1.
Determine an appropriate mounting position for the reader.
Ideally, for the maximum operating distance, avoid mounting
the reader directly on metal surfaces.
2.
Peel off the back of the self-stick mounting label template
included with the unit and position it at the desired mounting
position.
3.
Using the template as a guide, drill two holes (hole size is
indicated on mounting template) for mounting the reader to
the surface.
4.
Drill a 1/2″ (13 mm) hole for the cable. If mounting on metal,
place a grommet or electrical tape around the edge of the hole
to protect the wire from chaffing.
5.
Attach the reader to the mounting surface using the
appropriate screws (not supplied). The mounting
template
may be left in place if desired since the reader will cover it
completely.
HOW TO CONNECT THE READER TO THE HOST
The Reader is supplied with an 18-inchpigtail, having a
7-conductor cable. To connect the reader to the host, perform the
following steps:
1.
Prepare both the reader cable and host cables by cutting the
cable jacket back 1¼ inches and strip the wires ½ inch.
2.
Splice the reader pigtail wires to the corresponding host wires
and cover each connection (see Figure 1).
3.
Trim and cover all conductors that are not used.
Figure 1 below shows how you should wire the reader to the host.
Figure 1
Wiring Notes:
1.
The individual wires coming out of the reader are color coded
according to the recommended wiegand standard.
2.
When using a separate power supply for the reader, the reader
power supply and host must have a common ground.
3.
The recommended cable depends on the distance from the
reader to the host. See Table 1 below for the correct wire gage
based upon distance. Larger wire gauges (smaller numbers)
are desirable. The wire must be stranded with an overall
Red
+8~16VDC
Black
Ground
White
Data1
Green
Data0
Brown
LED Control
Purple
Tamper +
Orange
Tamper -
Honeywell
Model:JT-MCR45-32C