Honeywell VCU-05 Manual Do Utilizador

32

Route the interface and power cables from the wall to the reader 

through one of the three holes in the base of the swivel.

Route the cables through the swivel ball, being careful to ensure that 

the cables are on the same side of the connectors on the reader. Do not 

cross the cable inside the ball. Leave about 5-6 cm of excess cable.

Attach the swivel to the wall using the three screw holes, paying 

attention to the right position as shown in 

UP inside the base.)

Fix the swivel ball on the support by giving the desired slope. The 

swivel ball has a key to prevent you from installing the ball upside 

down.

Connect the cable to the 3.5mm Pitch Plugs and other connectors. Be 

sure to connect the wires by paying attention to the right position 

shown in 

 (the screws must be on the side of the Ethernet 

connector). Be sure that there are no short circuits between the wires.

Use the bayonet fitting shown in 

 to close the reader.

Use the 2x Torx screws to lock the reader onto the support. 

This support is used for installing the reader on horizontal surfaces. 

Typical installation is for the use on the turnstile.

Figure 20 Turnstile support (front and back views)