Hangzhou Gubei Electronics Technology Co. Ltd 3303-SBSL Manual Do Utilizador
Maintenance
1.Power rating: Input DC3.3V
2.Declaration of Conformity
Hangzhou Gubei Electronics Technology Co., Ltd. hereby declares that this Wifi
Module is in compliance with the essential requirements and other relevant provisions
of Directive 1999/5/EC.a copy of the original declaration of conformity may be found or
obtained at https://shop1413998575180.1688.com/
1.Power rating: Input DC3.3V
2.Declaration of Conformity
Hangzhou Gubei Electronics Technology Co., Ltd. hereby declares that this Wifi
Module is in compliance with the essential requirements and other relevant provisions
of Directive 1999/5/EC.a copy of the original declaration of conformity may be found or
obtained at https://shop1413998575180.1688.com/
FCC Caution.
This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference, and (2)
this device must accept any interference received, including interference that may
cause undesired operation.
Any Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation.
This equipment generates uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.
The distance between user and device should be no less than 20cm.
The Wifi module is designed to comply with the FCC statement. FCC ID is
2ACDZ-3303-SBSL. The host system using Wifi module, should have label
indicated it contain modular FCC ID: 2ACDZ-3303-SBSL